DIY Bow mount trolling motor bracket for a Jon Boat / Alumacraft 1236 | v bottom jon boat | #DIY #Bow #mount #trolling #motor #bracket #Jon #Boat #Alumacraft | 2022
Cleveland weather forecast: Major winter storm on the way | map of lakes in indiana | #Cleveland #weather #forecast #Major #winter #storm | 2022
January 27, 2023
$1,000 Fishing Lure Fools a GIANT Bass | best fishing reels for bass | #Fishing #Lure #Fools #GIANT #Bass | 2022
January 28, 2023
DIY Bow mount trolling motor bracket for a Jon Boat / Alumacraft 1236 | v bottom jon boat | Baking tips and tricks
alumacraft,1236,1436,1036,tin,boat,tinboat,jon,john,swamp,trolling,motor,stand,bracket,transom,transcom,haswing,cayman,helmsman,55,12v,bass,mount,i-pilot,minn,kota,motoguide,motorguide,frontmonterad,elmotor,drev.se,drev,takräckesbåt,tackräcke,båt
#DIY #Bow #mount #trolling #motor #bracket #Jon #Boat #Alumacraft
DIY Bow mount trolling motor bracket for a Jon Boat / Alumacraft 1236
Installing my new motor bracket on my Jon Boat.
The boat is a Alumacraft 1236
The motor is a Haswing Cayman Helmsman GPS 55lbs 12v
v bottom jon boat
Installing my new motor bracket on my Jon Boat.
The boat is a Alumacraft 1236
The motor is a Haswing Cayman Helmsman GPS 55lbs 12v
Related posts
March 22, 2023
March 22, 2023
March 22, 2023
March 21, 2023
March 21, 2023
March 21, 2023
March 20, 2023
March 20, 2023
March 20, 2023
18 Comments
just did mine today thanks for the idea will see how it works out
Not bad would have been a little better if the phone didn't keep going off
This makes my old motor look like a toy enjoyable.fishing recommend it's well built. I haven't had it on the water yet, but I'm very sure it will perform just fine.
How did this hold up, or is it not strong enough to hold the trolling motor?
I was unable to see the full mount 🤔
Laughing my booty hole off. When did the pair juice appear
Seems flimsy, how did it work?
Should the motor be in the centre like on a bass boat ? Or is it not important ?
That was probably the most primitive demo I’ve ever seen ! Great job
How thick was the Aluminum?
How's it holding up?
Was you able to bend it by hand?
Nice
Hej jöns . Jeg tror simpelthen Ikke min fjernbetjening er ok den blinker ikke og sender ikke Bluetooth signal . Kan du reset din kobling … og hvordan Tak for hjælpen
What was the first tool you used? The blue tool? Looks like rivet gun but it’s not?
turned out great. I have the minn kota 45 edge on it and works great. doesn't give a bit. really appreciate the idea!
I ended up going with 1/4 inch aluminum. I'll let u know how it holds. going to try it out saturday.
doing the same thing to my 14 ft. thanks. helped alot.